23
TROUBLE SHOOTING
TROUBLE SHOOTING
Problem
Possible causes
What to do
The display on the front
panel does not light up.
No sound or picture, but the
front panel shows red light.
Power line is not connected.
The
is in standby mode.
receiver
Check that the power line is plugged into
the power socket.
Press the standby button.
No sound or picture.
No signal or weak signal.
Check signal cable connections, antenna
and other equipment connected between
the antenna and the receiver.
Bad picture / blocking
error.
Signal is too strong.
Connect a signal attenuator to the
antenna input.
Antenna noise factor too high.
Change to an antenna with lower noise
factor.
The antenna is faulty.
Change the antenna.
The picture is not
displayed on the screen,
when switching on.
The system is connected by RF
leads.
Check the UHF channel fixed in your
system and tune the UHF channel
properly.
The system is connected by RF
leads and the output program of the
receiver interferes with an existing
terrestrial programs or Video signal.
Change the receiver output program to
a more suitable program, or connect the
system by SCART leads.
There is interference on
your terrestrial program
or video signal.
The RCU is not working.
Battery exhausted.
Change the batteries.
RCU is incorrectly aimed.
Aim RCU at the
, or check that
nothing blocks the front panel.
receiver
Note:
if you have tried all of the actions suggested above, yet problem still persists,
please contact your local dealer or a customer service adviser.
The recording was
automatically stopped.
The memory of your external drive is
not sufficient for recording.
Safely remove the external drive and
replace it with a new compatible drive.
The unit can not detect the
plug-in external drive.
The external drive is not compatible
with this unit; please refer to
Minimum
requirements on compatible external
drives
on Section 6 of this manual.
Choose a compatible external drive.
