background image

 

 
 

OPERATION 
Control Panel: (Figure 4) 

 

The  heater  may  be  operated  by  the  manual  controls  located  on  the  heater(as  shown  in 
FIGURE 4) or by the remote control(as shown in FIGURE 5) 
 
The heater must be placed on a flat floor or the tip-over switch will shut it off automatically. 

 

1.  When heater is plugged in and turn on the power switch on the side of the unit base, there 

will be a “beep” and a red power light to indicate that there is power to the unit. The red 
power light will be lit until the heater is unplugged from the power outlet. 

WARNING: Be sure plug fits tightly in power outlet. A loose fit will cause overheating 

and damage the plug.   

NOTE: Plug and cord set may feel warm during normal usage.

 

2. 

Power

 button. Press this button will start the heater. Upon turning the heater on, the unit 

will be in the 

FAN

 mode (25 watts) and the 

FAN

 indicator will be light. 

3. 

Mode

 button. When this button is pushed, LOW indicate light comes on and heater is in 

the low heat mode.(1100 watts) 

4.  Press the 

Mode

 button again and the LOW indicator light goes off and the HIGH indicator 

light comes on and the heater now is in HIGH mode (1800 watts). 

5. 

Timer

  button.  Press  it  once  and  the  light  comes  on  indicating  1/2  hour  of  time.  Press  it 

again and the light indicates 1 hours. Press it a third time and it indicates 1.5 hours. The 
total  time  that  can  be  indicated  at  one  time  is  7.5  hours.  Continuing  to  press  the 

Timer

 

button will cycle through the settings until all timer lights are off. When the time indicator 
lights are off, the heater will run continuously. 

6. 

Oscillation

 button. Press this button and the Oscillation light comes on and the heater will 

oscillate back and forth. Press it again and the light will go out and the oscillation will stop. 

7.  The  heater  must  be  placed  flat  on  the  floor  or  the  tip-over  switch  will  shut  it  off 

automatically.

 

 

8.  To disconnect heater, press “

Power

” button, and turn off the power switch, then remove 

plug from outlet. 

WARNING

DO NOT PLACE THE    HEATER UNDER A POWER SOCKET   
NEVER  LOCATE  THE  HEATER  INTO  BATHROOM  OR  OTHER  WET  OR 

Reviews: