42
Remove any insulation from the tube (1).
Place a shield (2) to protect the unit and unsolder the tubes at the ends
(A)(B).
Remove the screw (3).
Remove the condenser assembly (4).
NOTE: Be careful not to force the tubing too much or damage it.
NOTE: If the
fins
are compressed, use the appropriate comb to restore
them.
9.22
Evaporator assembly removal
Remove the body (Cf. 9.2 Body removal, on p. 32).
Remove the back (Cf. 9.6 Back removal, on p. 34).
Discharge the gas from the refrigerant circuit (Cf. 9.20 Charge/discharge
refrigerant, on p. 40).
Remove the insulation from the tubes (1).
Position a shield to protect the unit and then unsolder the tubes at the
end (A)(B).
Remove the mounting screw (3).
Remove the evaporator assembly (4) being careful not to compress the
fins
.
NOTE: If the
fins
are compressed, use the appropriate comb to restore
them.
