Olimpia splendid DOLCECLIMA SILENT S1 10P, Instructions For Installation, Use And Maintenance Manual

Page: 71 / 284

DOLCECLIMA SILENT S1
>>>>>
ENGLISH
EN - 27
d
. the temperature set-point is included between 17°C and 30°C (from 62 f and 86 f) with 1°C variations
and it can be set using the keys +/- on the control panel or with the keys ▲ ▼ on the remote control.
e
. after a certain time (maximum three minutes) after the activation of the operation mode, the heat pump
activates and the appliance starts delivering warm air.
f
. Connect the condensation discharge pipe (paragraph 2.6.b)
3.11 TIMER MODE
a
. this mode allows to program the switching on or the switching off of the appliance.
b
. the delay time can be set, activated and cancelled both from the remote control and from the control
panel.
3.11.a Programmed switching on
a . When the appliance is in standby mode, select the operation mode, the desired temperature and ventilation
speed.
- on the control panel: - press
and set the switching on delay time with the keys +/-
.
- to activate the function, press or wait approximately 5 seconds so that
the set time on the display stops flashing (the display returns to showing
the environment temperature).
the icon lights up.
- on the remote control: - press the key “ TIMER ON ” to access the function and then press the key
“ TIMER ON ” once or more until the switching on delay time is set.
- Direct the remote control towards the appliance; a beep confirms the acti -
vation of the function.
- the icon on the control panel and the indicator “
Timer On
” on the remote
control display light up.
b
. once the set time has passed, the appliance starts with the same settings (mode, temperature and ven-
tilation speed) as those before switching off.
c
. time can be set with 30 minutes steps up to 10 hours and with 60 minutes steps from 10 to 24 hours.
d
. Starting the appliance or adjusting the timer setting to “
0.0h
” will cancel the programmed switching on
function.
3.11.b Programmed switching off
a . When the appliance is running, set the delayed switching off time.
- on the control panel: - press
and set the switching off delay time with the keys +/-.
- to activate the function, press or wait approximately 5 seconds so that
the set time on the display stops flashing (the display returns to showing
the environment temperature).
the icon lights up.