3 USE AND MAINTENANCE MANUAL
03_OLI_00_IT_EN
38
SPORT
Error code
Description
0810
Signal of the current sensor not compliant.
0811
The drive has detected an overcurrent.
1101
Communication problem between HMI and drive. Check
that the wiring is correctly connected and intact.
1102
One key on the control panel is locked in the press position.
3.10.
TROUBLESHOOTING
The following table lists the main problems that can be found and the possible solutions to
be undertaken.
Problem
Cause/Solution
The system does not turn
on.
Check that the battery is properly in place and is charged.
Assistance does not
activate.
Check that the selected assistance level is greater than 0
and that the battery charge level is sufficient.
The display shows an error
message.
The system has detected a fault. Depending on the type
of fault, the motor could be deactivated or run at reduced
power. For more details refer to the paragraph “Error
messages”.
The display glass is fogged
up.
Due to sudden changes in the environmental conditions,
condensation may form inside the glass. The condensation
will disappear after temperature stabilisation.
WARNING:
If, after this operation, the problem persists, you must go to a service centre.
Summary of Contents for Sport
Page 3: ...0B_OLI_00_IT_EN 3...
