www.olarm.co/start
IDS X-Series Installation Guide
+27 21 009 0911 | [email protected] | www.olarm.co
E & OE. Terms & conditions may apply.
Page
2
2021-08-19
1. Ensure that the alarm system is powered up and on.
2.
Ensure the alarm is disarmed.
3. Press [#] to clear the keypad.
4. Enter the installer menu by typing the installer code
followed by a [*].
a.
The default installer code is [9999] or [999999].
b.
If these do not work, please contact the alarm
installer who installed / manages the alarm system.
5. From the installer menu, enter the code [196] followed by
[*].
9. The Olarm PRO should turn a solid blue colour within 2
minutes and you should then be able to control the Olarm PRO
from the olarm mobile app.
6. Enter the serial security code [123456] followed by [*].
7. Press [#] button 2 to 3 times until you hear 4 to 5 beeps
from the keypad, this will take you out of the installer menu.
8. The keypad will then display:
Do NOT
enter the Master Code at this stage, instead press [*]
which will then display the firmware version.
Configure the alarm panel
This section will guide you through entering a series of
codes / settings to allow the alarm panel and Olarm PRO to
communicate. The IDS X-Series alarm system caters for a
range of keypads and they all work slightly different. Please
follow the instructions relating to your keypad.
STEP 10
Please do NOT mount the Olarm PRO inside the alarm
box or near any other radio equipment. This will reduce
the signal strength and result in your device not
functioning correctly.
Mount the Olarm PRO
Mount your device using the screws and drill template
provided. We suggest mounting the Olarm PRO device on a
wall or on the outside of the alarm panel.
STEP 11
Troubleshooting
If your device LED remains flashing green for more
than 3 minutes - please check the connection between
the Olarm PRO and the alarm panel.
If your device LED is red - please check the
connection between the Olarm PRO and the alarm
panel.
If your device LED is orange - please ensure that the
Olarm PRO is located in an area with good mobile signal
strength. If it is not, please ensure that your device is
connected to WiFi using the wizard inside the Olarm
app.
If your device LED is not coming on - please check
the connection between the Olarm PRO and the alarm
panel and that the alarm panel is connected to power.
If your device LED remains purple for more than 15
minutes - please contact Olarm Support: +27 21 009 0911
or
.
To check your alarm panel firmware
version
Hold down the [*] key on the keypad down for 3 seconds. You
should see the following display:
TIP
