SET-UP
Check out the how-to videos on our website!
To remove your seamer from its box, lift as shown below. It is heavy (~45lbs) so
use caution while lifting.
Locate your seamer on a flat, level tabletop or bar-height surface. Make sure
there is enough room around the seamer to move around it easily.
Attach the lever arms (located in the accessories box that comes with the seamer)
by threading them into the holes located on the roller housings.
!ATTENTION!
Use a 7/16in wrench on the nut located between the shaft and knob to tighten
the handle into the roller housing. If the
handle’s
threads back out they will
bend or break over time.
!ATTENTION!
Canning is done in a wet environment, so always plug the
seamer into a GFCI outlet to avoid shocking hazards.
The power cable is located “under” the seamer
and held on with paper tape. You
can either tilt it forward and reach under to remove the cable or pull off the back
cover. The cover is attached using magnets. Just pull back to remove the cover.
-------------------------------------------------------------------------------------------------------------