18
•
Once you have done close the chamber and wait for 2 minutes in order to let the environment achieve
steady state; press on
Incubator Closed
and the temperature controller will resume operating
normally.
Figure 13. Open incubator
Opening the incubator can lead to controller instability since both the specimen and the
inside of the chamber are exposed to the external environment. In order to avoid the
problem, H101-CRYO-BL has to stay in a holding state until the incubator is closed and its
environment is in a steady state. This can be achieved using the Open Incubator procedure.
6.2.1.2
Objective Heater (optional)
Figure 14 shows how to enable/disable the Objective Heater (OBJ COLLAR ####). The Objective Heater is
disabled by default. Read this paragraph only if your system is equipped with Objective Heater (OBJ COLLAR
####).
Figure 14. Objective Heater enabling
Tip
►
Before enabling it, make sure it is already installed around your objective, and that it has been
correctly connected to the T-Unit.
When enabling and saving the Objective Heater the following Screenshot will appear:
1
2
