6
Operating modes
23
please read section
on page
To come back to the main menu press the button
(“Exit”). If you like to do a measurement
in
Scan Mode
you have to press the button
Start
(“Scan”).
6.1.2
Scan Mode
Inside the
Scan Mode
of the operating modes
Fast Scan Mode
and
Deep Scan Mode
you
have the possibilities to detect buried structures like e.g. voids. During this measurement
method the
transmitter
is activated and generates vibrations into the ground. Furthermore there
is the possibility to store the measurement, transfer it to a computer and represent it as a
threedimensional graphic and finally analyse it.
The exact procedure to record a measured area is described in detail in section
on page
There the exact procedure of a complete measurement in
Scan Mode
of the operating
mode
Deep Scan Mode
is explained in detail. All important steps beginning from preparing a
measurement, to recording data up to transferring data to a computer will be explained. That
is why we set this matter aside in this section.
Before you start the measurement in
Scan Mode
we recommend you a first check in
Check Mode
.
So all seismic interferences can become visible.
For a detailed analysis of the recorded measurement values please read the section
on page
6.2
Delete Recording(s)
Select the operating mode
Delete Recording(s)
, to delete older measurements from the internal
memory. Because of security reasons after the first confirmation you will be asked again to
confirm the deletion of the measurements.
Figure 13: Security check before deletion of measured values
A small submenu like in figure
will appear where you can select
Yes
or
No
. If you select
Yes
in this submenu and afterwards press the button
all available data will be deleted from the
OKM Ortungstechnik GmbH
