P.I.C. = Product Item Code
Copyright 2011. All Rights Reserved.
PAL Version Also Available
www.okinausa.com 7
R042011-V07
6
3
2
1
0
7
5
4
1
Lens Mount
U
sed to install a CS mount lens. CS adaptor ring is required if using a C mount lens.
2
CS Mount Fixing Screw
Screw for fixing mount and adjusting back focus if needed.
3
Mount Adaptor
Can be attached to either the top or bottom of the unit.
4
Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto-iris lens (not supplied) with DC power and a video signal
or DC control signal.
5
ME / AES Shutter Control
(0) 1/100 (120) sec.
(1) 1/190 sec.
(2) 1/350 sec.
(3) 1/610 sec.
(4) 1/1120 sec.
(5) 1/2000 sec.
(6) 1/3240 sec.
(7) 1/4000 sec.
6
Control Switch
SW1. BLC: Back Light Compensation OFF/BLC switch
SW2. FLC: Flickerless NORM / FLC switch
SW3. AGC: Automatic Gain Control AGC/S.AGC switch
SW4. Sync Mode: Sync Mode Selection L.L/INT switch
7
Video Connector
Output for connecting to a video monitor or recorder.
8
Auto Iris Mode Selection Switch
For switching the output from the auto iris connector. Shutter speed is fixed at
1/100(120) sec. when switch is set to DC or VIDEO position.
DC:
To be set when using an auto iris lens. Be sure to adjust proper DC level for
D/N operation.
CAR-DC:
To be set when using for license plate capture. (Car speed is up to 90mi/hr (150km/hr)
at daytime and 90 mi/hr (150 km/hr) at night time with external IR LEDs).
VIDEO:
To be set when using an auto iris lens with built-in amp.
9
V.P. (Vertical Phase) Adjustor
Used to adjust the vertical phase of the video output signal.
Power Input Terminal
Connect the power supply of 12V DC or 24V AC.
○
11
External D/N Input Controller
Connect to an external IR illuminator and the camera can be triggered from daytime to
nighttime mode by output controller of the IR illuminator. There are 2 methods to connect to the
external IR illuminator.
Method A:
Connect the IR illuminator with Pin1 and Pin2.
Pin1: 5V~12V Pin2: GND
Method B:
Connect the IR illuminator with Pin2 and Pin3.
Pin2: GND Pin3: OUT
○
12
Y/C(S-Video) Output Terminal
Separate Y(brightness) and C(Color) signal are outputs from this terminal to obtain better video
quality at a video monitor.
PIN NO.
VIDEO
DC
1
DC + 12V
CONTROL -
2 NC
CONTROL
+
3
VIDEO SIG
DRIVE +
4 GND
DRIVE
-
