6.OSD - System Setting
Some products may not be available in your country, please contact our distributor for more details
Some products may not be available in your country, please contact our distributor for more details
13
6.OSD - Motion, Clear, Password
System Setting
In the system setting menu, you can modify operation
and display settings, such as dome label, temperature
and display of various values on the operational
screen.
EDIT DOME LABEL
LABEL
BACK
EXIT
：
ENTRANCE
INITIAL INFO
FIRMWARE
2:33
V
PROTOCOL：FACTORY
DOME ADDRESS：001
COMM：4800,N,8,1
BACK
EXIT
SYSTEM SETTING
EDIT DOME LABEL
INITIAL INFO
DISPLAY SETUP
MOTION
CLEAR
PASSWORD SETUP
BACK
EXIT
Initial Info:
Shows the information about current settings.
Dome Label:
1. use UP or DOWN to change the character.
2. use RIGHT to move to next character.
3. use RIGHT to move to last char. and to save.
4. use Left to go to first char. and to cancel.
Display Setup
Dome label:
Preset label:
Zoom label:
Zone label:
Direction label:
Temperature label:
Enables the display for the on-screen info during
operaton mode.
Name of the dome
Shows the label of every preset
Shows zoom factor on screen
Shows the zone name
Shows the coordinates
Shows the current temp. in
the dome
DISPLAY SETUP
DOME LABEL
OFF
PRESET LABEL
OFF
ZOOM LABEL
ON
ZONE LABEL
OFF
DIRECTION LABEL
ON
LABEL
OFF
BACK
EXIT
TEMPRATURE
14
MOTION
Motion control
AUTO FLIP
,
PROPORTIONAL PAN:
PARK TIME:
: Auto. image flip tilt range from 90° to
180°.
Depending on the zoom
factor, the dome will adjust the pan and tilt speed
automatically for comfortable viewing.
Defines the idle time prior to start a
custom defined action (park action).The duration can
vary from 1 to 240 minutes. This function can
bedisabled by setting the minute to 0.
PARK ACTION:
POWER UP ACTION:
FAN ENABLED
The action which will be started after
the idle time (park time). Selectable between Preset,
Scan, Pattern (Nr), Tour or None.
Action which starts after power
up and self test. Selectable between Auto, Preset 1,
Scan, Pattern (Nr), Tour or None. By selecting Auto,
the dome will resume the last action before power off.
: Defines the temperature limit (in °C)
at which the internal cooling starts operating. The
standard limit is 40°C.
AUTO FLIP
ON
PROPORTION PAN
ON
PARK TIME
005
PARK ACTION
SCAN
POWER UP ACTION AUTO
FAN ENABLED
040
BACK
EXIT
Clear
You can clear setting’s memory or reset the camera to
factory default. The follwing functions are supported:
- Clear all zones
- Clear all presets
- Clear all patterns
- Clear all tours
- Clear all windows
- Factory defaults
Warning
:
The clear action cannot be undone.
Once an item is cleared it is impossible to
retrieve the deleted setting. Please make sure
that the requested clear action is desired.
CLEAR
CLEAR ALL ZONES
CLEAR ALL PRESETS
CLEAR ALL PATTERNS
CLEAR ALL TOURS
CLEAR ALL WINDOWS
FACTORY DEFAULTS
RESTART
BACK
EXIT
O
NEW PASSWORD
: ******
ENABLE PASSWORD OFF
BACK
EXIT
LD PASSWORD
: ******
CONF PASSWORD : ******
PASSWORD SETUP
Password setup
You can change password to access the OSD menu.
Default Password is 000000.
