OKIDATA Microline 395, Service Handbook

Page: 60 / 178

%3.2.20 Paper Pressure Guide
3.2.20 Paper Pressure Guide
1. Remove the two springs (1) located on each side of the paper pressure guide (2).
2. Remove the detent spring (3) located on the release lever at the right side of the printer.
3. Separate the claws and remove the release lever (4).
4. Remove the release link.
5. Remove the paper pressure bar (5) by sliding it to the right.
NOTE:
The flat side of the paper pressure bar faces up.
6. Using needle-nose pliers, squeeze the nylon latch (6) to release the switch harness (7) which is
located at the left side of the printer mechanism.
7. Lift and remove the paper pressure guide.
P/N 50907502 Spring: Paper Chute RSPL B.2.07, 10
P/N 50910201 Spring: Detent (Release Lever) RSPL B.2.07, 10
P/N 50910305 Spring: Idle Gear RSPL B.2.07, 10
P/N 51214401 Gear: Idle (Release Lever) RSPL B.2.07, 10
P/N 53478706 Lever: Release RSPL B.2.07, 10
P/N 53478801 Block: Release Lever Guide RSPL B.2.07, 10
P/N 55034801 Sensor: Cut-Sheet Paper-End RSPL B.2.07, 10
ML395 ( 96-02-03 )