UNINET IMAGING INC.
•
OKIDATA C 7000 / 7100 REMANUFACTURING INSTRUCTIONS
11124 Washington Blvd., Culver City, California U.S.A. 90232 Ph: 310 280-9620 • Fx: 310 838-7294 • [email protected]
© 2005 Uninet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. Uninet Imaging does not guarantee or warrant downloaded information.
USA
+1-310-280-9620
+1-310-838-7294
Ph:
Fx:
JAPAN
+81-3-44-55-2789
+1-310-838-7294
EUROPE
+34-93-757-1335
+34-93-741-4166
BRAZIL
+55-11-4822-3033
+55-11-4822-3353
ARGENTINA
+54-11-4571-2388
+54-11-4574-3706
www.
u n i n e t
imaging.com
19. Pull out the fuse holder located on
the side of the cartridge.
18. Remove the wiper blade as shown.
20. After cleaning and refilling the car-
tridge, replace the fuse and reassem-
ble the cartridge by following the steps
in reverse order.
12. Slide the end cap with axle out
completely.
13. Remove the screws on the remain-
ing end cap (gearside) that hold it in
place.
14. Remove the end cap with gears as
shown.
15. Remove the developer roller as
shown.
16. Remove the OPC drum as shown.
17. Remove the two screws on both
ends of the wiper blade that hold it in
place.
