1
Installation
1. Unpack the tractor. Remove the shipping materials.
2. Turn off the printer.
3. Remove the gear cover (1): push up on the tab (2),
then twist it off. This provides access to the
mounting post (3).
F6_2_03.jpg
4. Pull up the sheet stacker (1) to make room for
installing the push tractor.
5. Install the Rear Push Tractor on the printer. It
mounts on the posts inside the stacker:
While holding the lever (1) on each side of the Rear
Push Tractor, slip the U-shaped brackets (2) at either
end of the tractor under the posts (3), inside the
stacker support bracket, behind the stacker roller
(4). Rotate the tractor down and release the levers
to fasten it in place.
(continued on back)
F6_2_04.jpg
ML881
0 RFT F03 rev.JPG
ML8810 RFT F03_a rev.JPG
ML8810 RFT
F03_b.jpg
English
Rear Push Tractor Installation Instructions
English . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Français . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Español . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Português . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
