Oki ML4410, User Manual, Page: 27 / 122

Operation 19
Engl
is
h
a slower speed. Graphics printing can also be optimised by adjusting the
registration of the print head.
Host Interface: Selects which interface the printer uses to receive printing
commands. Auto setting - the printer automatically switches interface
depending on the received data. Parallel setting - where only a parallel
interface is used. Serial setting - where only a serial interface is used.
I/F Time Out: Sets the length of time before the interface switches to idle
status when no printing commands have been received.
Impact Mode: Selects the impact mode used when printing. The settings
are normal mode, quiet mode for low noise printing and hi-copy mode
when printing using multiple copies.
Intr Chr Sub St: Epson mode only - enables or disables the code page
settings and switches to allow for foreign language conversion and
combination.
Language Set: Changing the language set replaces certain standard
symbols with special characters used in foreign languages.
LF Speed: Selects the line feed speed - fast or slow.
Line Spacing: Select 8 LPI to print more lines on a page.
OP Func.: Changes the operator panel to limited operation. This prevents
any special printer settings from being changed via the control panel when
several people are using the printer.
Page Length: Set this to match the length of the paper you are using
enabling the printer to keep track of the initial printing position of each
page (TOF).
Page Width: Change to 8" to print on letter size paper.
Pitch: Choose the character width in characters per inch (CPI).
Ppr Out Override: Senses when less than 25 mm of paper remains and
stops printing. Change to yes to override the sensor. Please note that
changing this setting to yes can cause loss of data and damage the print
head.
Print DEL Code: Oki mode only - change the setting to Yes if you want
to print the DEL code (decimal 27) as a solid box.
Print Mode: Choose the quality and font for printing.
Print Suppress: If your system uses the DC1 and DC3 codes for
something other than the print suppress mode, change the setting to no.