Oki ML4410, User Manual, Page: 26 / 122

18 User’s Guide
Explanation of Menu Items
General
# Graphics Bits: Oki mode only - choose the graphics your system uses,
either 7 or 8 bit data.
Auto CR: IBM mode only - if you want the printer to automatically add a
carriage return when a line feed is received at the end of a line, change the
setting to yes.
Auto LF: Automatically adds a line feed to each carriage return command
the printer receives. If your printout is consistently double spaced, select
no. If your printout consistently overprints, select yes.
Auto Path: When set to valid, automatically feeds paper from the unused
paper path when paper end is detected and continuous printing is required.
Auto Select: If you always use the same top of form position, change the
setting to yes.
Character Set: Select which character set the printer uses as default when
printing.
Code Page: Choose the code page for the character set you wish to use.
Data Word Size: Oki mode only - if your computer system uses seven bits
to make up each unit of data, change this setting to 7.
Default Path: Sets which paper path is used during printer initialisation.
Current path sets the paper path to the paper path in use when the printer
was switched off. Rear path always sets to the printer to use the rear path
on initialisation. Front path always sets to the printer to use the front path
on initialisation.
Emulation Mode: Choose the emulation mode you want to use for your
printer. IBM Proprinter, Epson FX or Oki Microline.
ESC SI Pitch: IBM mode only - sets details of the ESC SI command. 17.1
CPI sets ESC SI to condensed mode and 20 CPI sets ESC SI to to 20 CPI
setting.
Form Tear-Off: Choose 500 ms, 1 sec, or 2 sec to turn this feature on and
to set the time interval for the printer to wait before advancing the paper to
the tear-off position.
Graphics: Default setting is bidirectional for faster printing of graphics.
Unidirection (left to right only) gives a better graphics print registration at