7.Push in the adapter just until the connectors begin to engage, then swing the adapter down and
press on it until the tabs engage the tabs on the printer housing (youll hear a loud snap).
8.While pressing down on the top of the adapter, grasp the molded finger grips and push in the
adapter until the parallel interface connection is firm. If you have installed the adapter properly,
you will not be able to lift it and the hole in the metal tab will align with the screw hole on the
printer housing.
9.Secure the adapter in place by installing the grounding screw in the metal tab.
10.Enter the Menu Select mode (see page 45) and change the item Interface under the General
Control group from Parallel (factory default) to Serial.
To remove the serial interface adapter, first remove the screw from the metal tab. Then, push on
the molded finger grips to gently pry the adapter off the connector, and lift it out.
Be sure to save the screw with the adapter_youll need it should you ever wish to reinstall the
adapter.
ML 380 ( 96-02-03 )
Summary of Contents for ML380
