6
2.
Run & Manual Mode
1.
Turn on the unit by pressing the Power button
.
2.
HCT start-up message and Software Rev # are momentarily displayed
before displaying last-used profile settings.
Note
: The unit may display
MRS-1000 if that was the last operational state.
3.
IMPORTANT
~ If “TC:
Ext
” is displayed on the panel (see Figure 4
above) ensure that the external thermocouple is suitably positioned in the
heat path. Neglecting to do this could result in premature heater failure
4.
Select the desired profile.
5.
When the chosen profile is shown, press
(
↵
)
to
select the desired profile
6.
To start the profile, depress the
(red) on the footswitch or
(red) on
the hand-piece once
7.
As the profile runs you will see the current zone, time remaining, heater
value and temperature set point. Manual mode profiles will display
“Manual” and will not display time remaining.
8.
To quit the profile, simply depress the
(red) on the footswitch or
(red) on the hand-piece continually for 3 seconds. The profile will skip to
the Cool-Down Zone.
Note:
Repeating step 8 turns off the Cool-Down
Zone after a minimum of 60 seconds of cooling.
3.
Active Setup Mode
1.
Select Profile to be modified as per steps 1
3 above
2.
To activate Active Setup Mode press
(
↵
)
for 3 seconds then depress the
(red) on the footswitch or
(red) button on the hand-piece once the
temperature in Z1 has started to flash
3.
Profile will start to run and ‘SETUP’ will be displayed on LCD
4.
To modify the current zone set-temperature use the
⊕
/
buttons
5.
To
increase
the time of the current zone press and hold the
(
↵
)
button as
the zone ends. Instead of stepping onto the next zone the current zone
time-setting will increment the original setting for as long as you keep the
(
↵
)
button depressed. Releasing the button will allow the profile to
progress onto the next Zone.*
6.
To
decrease
the zone time, depress the
(red) on the footswitch or
(red) button on the hand-piece at the desired time. This will set the time
to memory and advance the profile into the next zone.*
Note
: Steps 3.4.5
& 3.4.6 can be carried out simultaneously
7.
Once required changes have been made, allow the profile to finish. Press
and hold
(
↵
)
, until the LCD tops flashing, to set the profile to memory and
exit setup mode
8.
*
Note
: feature not available in Cool-Down Zone
5.
Additional Features
1. Integrated Vacuum Pick-up
The vacuum pick-up tube has 1.0” (25.4 mm) of travel and is spring loaded
to prevent damage to components during attachment.
Use an appropriate sized vacuum cup to make a seal on the component.
2. HCT System Mode
1.
Press the
(blue) on the footswitch or
(blue) on the hand-
piece once to activate the vacuum pump and again to deactivate.
3. MRS System Mode – Place or Remove selection