253
Power Setup
Check All
Sectors
No
Yes
Performs recovery of a defective HDD
sector information and a file system
mismatch as mentioned above.
It takes 30 to 40 minutes to complete
this function for an HDD of 10GB.
Enable HDD
No
Yes
Even if a machine is inoperable at
installation because an HDD has
been damaged, you can make the
machine operable by setting to NO to
signify that no HDD is attached,
regardless of the existence of an
HDD. While NO is set, access to an
HDD results in FAIL because the HDD
is regarded as not attached even if the
HDD is operating normally.
Enable
Initialization
No
Yes
Prevents a setup change
accompanying initialization of Block
Device (HDD, FLASH).
Item
Value
Description
Peak Power
Control
Normal
Low
The fuser of the printer has two
lamps. When the lamps turn on, the
printer’s power draw increases
dramatically.
Normal: Both lamps light at the same
time. When this happens, the printer’s
power draw increases dramatically.
Low: The lamps do NOT light at the
same time. The printer’s electrical
draw increases, but not as
dramatically.
Power Save
Enable
Disable
Enables/Disables the power save
mode.
Item
Value
Description