Oki B6200 Series, Maintenance Manual

Page: 141 / 679

2 - 17
Chapter 2 Operation of Diagnostic
6. If there is no applicable chain-link No., the NG screen is displayed as shown below. In this case,
press the "FEED / SELECT" key to return to the chain-link No. input screen.
7. If you want to terminate the execution of components, use the "CANCEL" key. Then, using the "
↑
"
or "
↓
" key allows you to show the next (previous) component.
8. Pressing the "FEED / SELECT" key allows you to restart the execution of components under
suspension.
9. If you want to change a component output, you must go to the output change screen.
(1) On the monitoring list screen in progress, use the "
→
" key to show the output change screen.
(2) To set the output value, move the cursor using the "
←
" or "
→
" key and change a numerical
value using the "
↑
" or "
↓
" key.
When the cursor is positioned at the left end of the input or output value, pressing
the
"
←
" key allows you to return to the monitoring list screen in an upper hierarchical
level.
(3) The changed output value is fixed by pressing the "FEED / SELECT" key. Then, you are
brought back to the monitoring list screen.
10. If you want to cancel the operation of all the components, you must go to the [DC140 Monitor Can-
cel All] screen.
(1) On the monitoring list screen in progress, use the "
←
" key to return to the [DC140 Monitor
Component List] screen in an upper hierarchical level.
(2) Select [DC140 Monitor Cancel All] in the same hierarchical level using the "
↓
" key.
(3) Show the [Cancel All If OK press SEL] screen using the "
→
" key.
(4) Press the "FEED / SELECT" key to cancel the operation and listing of all the components. The
[Cancel All In progress] screen is shown during cancellation.
(5) After the cancellation has been completed, the [Cancel All If OK press SEL] screen is shown
again.
11. Press the "MENU" key to return to the common menu screen [Diag. Menu Fault Diag.].
Component List
009-002 OUT 030*
Component Input
009-002 NG
Change Component
009-002
030