27
EN
Fig.
10
Setting the timer
The timer switches the product on or into standby when a user-defined time has elapsed.
When switching on, the last mode and setting will be used. The set durations will be counted
down immediately after the input without correlation to the contrary time setting.
1.
Press the timer program button TIMER at the product or the specific TIMER ON/OFF
button at the remote control to enter timer setting for either the auto-on or auto-standby
timer. The respective indicator for each setting will light up.
2.
Press the
/
buttons or the specific TIMER ON/OFF button at the remote control as
often as necessary to set a time from 0.5 to 24 hours.
3.
The setting will be saved after 5 seconds without input.
Examples:
• To have the product switched off after 1 hour and on again after another 1 ½ hours, set the
auto-off time to 1.0 h and the auto-on time to 2.5 h during operation.
• To have the product switched on after 8 hours and off after another 8 hours, set the auto-
on time to 8.0 h and the auto-off time to 16.0 h while in standby.
Notes:
• The adjusting increments are 0.5 hours up to 10 hours, then 1 hour up to 24 hours.
• The respective indicator will be lit, when a time is set.
• Switching the product on or into standby manually will cancel the timer setting.
• The timer settings will be lost once the respective actions were conducted and the time
needs to be set again.
• The timer setting will be lost in case an error occurs (see protection and error codes).
Preprogramming a function
By pushing the SHORTCUT button any function and temperature can be saved and recalled.
1.
Choose your desired function e.g. using the MODE, TEMP /
or /
and FAN buttons, etc.
2.
Press and hold SHORTCUT button until the display flashes one time to save the setting.
3.
The preset setting can be recalled anytime and from any mode by simply pushing the SHORTCUT
button.
Fig.
11
WATER DRAINAGE
Water is only collected during automatic AUTO, cooling and dehumidifying mode .
During dehumidifying mode water is drained immediately through the upper drain outlet
and the drainage hose must be continuously connected. The water is drained through the
hose into a suitable container or nearby drain.
WARNING – Danger of flooding! Do not leave the product unattended when draining to an
external container! Empty the container frequently to avoid spilling over and water damage.
During automatic AUTO and cooling mode water is collected in an internal tank, which
must be drained when full. In this case the product will emit an audible signal, while the
display on the control panel is showing the protection code
P1
. The cooling process will stop
until the water is drained and the product restarted, while the fan remains running.
1.
Disconnect the product from the power supply.
2.
Place the product with the lower drain outlet above a suitable container or a drain.
3.
Remove the cover of the lower drain outlet.
4.
Attach the cover of the outlet again, when all water is drained.
5.
Connect the plug to a suitable socket.
6.
The product is ready to be switched on.
IM_OAC2221_161201_V04_HR.indb 27
1/12/16 4:31 PM
