3
Insert the battery into the base of the tool. To remove the
1.
battery from the tool, press the battery tabs and pull.
Insert the correct blade into the front of the tool and lock in
2.
place (see blade installation on page 4 for more details).
Select the appropriate impact setting based on seating
3.
requirements. With two fingers you can easily switch to a high
or low impact setting by turning the red adjustment knob.
Position the wire to be seated on the block
4.
The trigger has a dual function design. Squeeze lightly and
5.
hold to illuminate the target area with the built in LED light.
Next place the blade over the wire to be seated and push
forward to partially seat the wire. Squeeze the trigger fully to
complete the punchdown. The wire is now seated. If you are
using a blade with a cutter – the excess wire has been trimmed.
If the wire has not been cut, repeat the process.
OPERATING INSTRUCTIONS
