4
temperature control dial to the right (clockwise) to increase the desired temperature and to the left
for lower temperature. This temperature control dial can only be used while the 0/I switch and
1250W switches are in the ON position.
Note: When the O/I switch is turned off, all other heater functions will stop even though the
switches may be in the on position.
Maintenance
WARNING:
Disconnect power before attempting any maintenance or cleaning to reduce the
risk of fire or electric shock.
Cleaning
Before cleaning any parts of the fireplace make sure to first turn off the controls and then unplug
the unit from power source.
CAUTION:
Wait until the unit has completely cooled before attempting any cleaning.
Cleaning glass door: Remove dust with clean dry cloth. Remove fingerprints and other marks
from glass door by using a clean damp cloth. Do not use abrasive cleaners or spray liquids on
glass door surfaces.
Metal and metal painted parts should be cleaned with clean damp cloth only. Do not use abrasive
cleaners or spray liquids on this surface.
Replacing the Log/Flame Effect Light Bulbs
There is one 40-watt light bulb located under the log-set bed. Remove the 4 screws on the cover
located on the back of fireplace and then remove the rear cover of the unit.
CAUTION
: The bulbs in your unit can become extremely hot. Allow at least 15 minutes
between turning off the unit and removing the light bulbs to avoid hot bulbs coming in contact
with the skin.
To remove bulbs: Hold socket and pull the old bulbs out.
To replace bulbs: Hold socket and push in the new bulbs
Help Hints: For convenience, if one light bulb burns out, it may be a good idea to replace both of
the light bulbs at the same time.
