2
6.
Do not use outdoors.
7.
This fireplace is not intended for use in bathrooms, laundry areas and similar
indoor locations. Never locate fireplace where it may fall into a bathtub or other
water container.
8.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or
the like. Arrange cord away from traffic area and where it will not be tripped over.
9.
To disconnect fireplace, turn controls to off, then remove plug from outlet.
10.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening
as this may cause an electric shock or fire. Or damage the heater.
11.
Connect to properly grounded outlets only.
12.
To prevent a possible fire, do not block air intake or exhaust in any manner. Do
not use on soft surfaces, like a bed, where openings may become blocked.
13.
All electrical heaters have hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint, or flammable liquids are used or stored
14.
Use this fireplace heater only as described in this manual. Any other use not
recommended by manufacturer may cause fire. Electric shock. Or injury to
persons.
15.
Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire. However, if you have to use an extension cord, the cord shall
be No.16 AWG minimum size and rated not less than 1875 watts.
16.
When storing or transporting the unit and cord. Keep in a dry place, free from
excessive vibration and store so as to avoid damage.
SAVE THESE INSTRUCTIONS FOR FUTURE USE.
SAFETY INSTRUCTIONS
This electric fireplace heater is for use on 120 volts. The cord has a plug as shown at
A in Figure 1. An adapter as shown at C is available for connecting three-blade
grounding-type plugs to two-slot receptacles. The green grounding plug extending
from the adapter must be connected to a permanent ground such as a properly
grounded outlet box. The adapter should not be used if a three-slot grounded
receptacle is available.
