OK International MFR-1300 SERIES, User Manual

Page: 7 / 56

Cha
On / Ready
nuity fault,
•
Off------
se part number MFR-DC10 for replacement chamber cartridge, flux filter and in-line fume
ure good vacuum check all filters, hoses, coil assembly seal and desolder cartridge for
ED Indications and Meaning
uto-Sleep and Auto Off Functions
prolong tip life, MFR systems with a soldering hand-piece (MFR-H1-SC, MFR-H2-ST)
and,
engaged when
SmartHeat® & Calibration
lishes and retains heater idle temperature by virtue of Curie effect
•
Off------
se part number MFR-DC10 for replacement chamber cartridge, flux filter and in-line fume
ure good vacuum check all filters, hoses, coil assembly seal and desolder cartridge for
ED Indications and Meaning
uto-Sleep and Auto Off Functions
prolong tip life, MFR systems with a soldering hand-piece (MFR-H1-SC, MFR-H2-ST)
and,
engaged when
SmartHeat® & Calibration
lishes and retains heater idle temperature by virtue of Curie effect
U U
filter.
To ens
filter.
To ens
blockages.
blockages.
L
L
nnel LED
•
Green--------------
•
Red----------------- Ground conti
No tip cartridge,
No power wer
------------ Channel not ------------ Channel not
selected or auto off selected or auto off
A/C Power LED
On
ound Fault
•
Green----Power
•
Red------ A/C Input Gr
•
Off-------- Power Off
A A
To To
include an “Auto-Sleep Workstand” (WS1). When the hand-piece is placed into the workst
the “Auto-Sleep Workstand” immediately reduces power to the hand-piece.
All MFR systems have an “Auto Off” Function. The “Auto Off” Function will be
include an “Auto-Sleep Workstand” (WS1). When the hand-piece is placed into the workst
the “Auto-Sleep Workstand” immediately reduces power to the hand-piece.
All MFR systems have an “Auto Off” Function. The “Auto Off” Function will be
the hand-piece has been idle in the sleep stand for a period of two hours. The channel LED
indicator light will go from green to Off. The “Auto Off” Function can be reset by cycling the
power switch.
the hand-piece has been idle in the sleep stand for a period of two hours. The channel LED
indicator light will go from green to Off. The “Auto Off” Function can be reset by cycling the
power switch.
SmartHeat® technology estab SmartHeat® technology estab
inside the heater core. This phenomenon occurs at the atomic level and consequently idle
temperature cannot shift over time nor can it be altered by the operator. Accordingly the system
requires absolutely no calibration. Contact us at support@okinternational.com
inside the heater core. This phenomenon occurs at the atomic level and consequently idle
temperature cannot shift over time nor can it be altered by the operator. Accordingly the system
requires absolutely no calibration. Contact us at support@okinternational.com
7