OJ ETO2, User Manual, Page: 12 / 96

Set temperature for Zone 1: The temperature at which the ice and snow melting
system will become active can be set here. The temperature setting can be
adjusted from +50 / -20°C (122 / -4°F). Set the required temperature and press OK.
Set temperature for Zone 2: The temperature at which the ice and snow melting
system will become active can be set here. The temperature setting can be
adjusted from +50 / -20°C (122 / -4°F). Set the required temperature and press OK.
The lowest operating temperature for Zone 1 can be set here. Below this tempera-
ture, the system will enter standby mode. The adjustment range goes down to
-20°C/OFF (-3.9°F/OFF). OFF = no limit. To change the minimum cut-off tempera-
ture, press OK, turn the encoder button to the desired value and confirm with OK.
The lowest operating temperature for Zone 2 can be set here. The adjustment
range goes down to -20°C/OFF (-3.9°F/OFF). OFF = no limit. To change the
minimum cut-off temperature, press OK, turn the encoder button to the desired
value and confirm with OK.
Afterrun time Zone 1 : An afterheat duration of between 0 and 18 hours can be set
here. The system will continue to provide heat for the specified time after the
moisture/temperature signal has been eliminated by a heating cycle. Use the
encoder button to set the required afterrun time and press OK.
English ETO2
10
© 2011 OJ Electronics A/S
SET TEMP 1 3.0C
SET TEMP 2 3.0C
AFTERRUN 1 2:00
OFF TEMP 1 OFF
OFF TEMP 2 OFF
All manuals and user guides at all-guides.com