Oilon ESi 6-17, Installation And Operation Manual

Page: 35 / 80

The left column shows the current measured values, and the right column the
corresponding settings.
Resistor runtimes
are run times for the electric immersion
heater’s different power stages.
Use the arrow buttons at the bottom of the screen to navigate between the different
pages in the view.
Measurements 2 ver. 1
4.4.7 Heating curves
Each heating circuit (HD) is controlled based on a heating curve consisting of seven
temperature points. Depending on the system layout, the control system controls 1–
3 heating circuits or a combination of 1–2 heating circuits and domestic hot water
temperature.
Heating circuit 2, heating circuit 3, and domestic hot water temperature
limitation are optional accessories.
The heating circuit selection menu provides access to each circuit’s heating curve as
well as the Hot water temperature limiter function, see section
Boiler settings
.
Heating curve selection ver. 1
Adjusting heating curves
The heating curve window shows a number of outdoor temperatures as well as the
associated setpoint values (
Settings
) and adjusted values (
Modified
).
M8010 2204EN 33 (75)