OHM BootiQue Active System, User Manual

Page: 6 / 10

AMP PANEL Continued
6
14 Fire Alarm Muting
Allows the unit to be installed in a location
covered by a voice alarm fi re system with a
choice of voltage on or voltage muting.
15 & 16 Speaker Outputs Right/Left
On Binding Posts accepts up to 4mm heavy duty
wire or Pomona plug, wired as follows: Stereo
use:
Channel A, Red = Positive, Black = Negative
Channel B, Red = Positive, Black = Negative
17 IEC Fused Mains Inlet (230V)
A heavy duty lead is provided. If the panel
fuse fails always replace with a correctly rated
substitute.
18 On/Off Switch
Turns the unit on and off completely.
Note:
If powered off the whilst using MP3 playback,
the MP3 will require some time to reset. It is
recommended that you wait for approximately 7
seconds after power down before switching the
amplifi er back on.
8 Auto Power Switch
Senses if signal is present and switches on or
off accordingly. Unit remains in standby mode
until a power source is detected.
9 iPod Input
Allows the connection of an iPod or other mp3
player or auxiliary music source.
10 Phono Input
Use standard RCA plugs wired as follows:
Sleeve = Ground, Tip = Live
12 USB Input Socket
USB socket to take USB peripherals such as
mp3 players and Flash Drives with MP3 tracks
on. When used with a fl ash drive the remote
control is used to control track selection and
navigation.
10 Phono Link
Use standard RCA plugs wired as follows:
Sleeve = Ground, Tip = Live
13 RJ45 Input
Connects the BootiQue system to the wall
mounted remote control panel. Via CAT5
network ethernet cable maximum length 5m.
FRONT LED PANEL
1 Left Signal level Indicator
Indicates the dB level set by the gain control.
2 Sub Signal level Indicator
Indicates the dB level set by the Bass Gain
control.
3 Right Signal level Indicator
Indicates the dB level set by the gain control.
4 Stand LED (Yellow)
When lit indicates that the unit is in standby.
5 Power LED (Blue)
When lit indicates that the unit has power.