background image

Öhlins products are subject to 

continuous improvement and 

development, therefore, although 

these instructions include the most 

up-to-date information available at 

the time of printing, minor updates 

may occur. 

To find the latest information 

contact an Öhlins distributor. 

Please contact Öhlins if you have 

any questions regarding the 

contents in this document.

SET-UP DATA

Warning!

Before riding, always make sure that the basic settings 

made by Öhlins are according to recommended  

Set-up Data. Read about adjustments and setting up 

in the Öhlins Owner’s Manual before you make any 

adjustments. Contact an Öhlins dealer if you have any 

questions about setting up.

ADJUSTMENTS

Part no. MI_YA559_EN_1

Issued 2016-04-26

Recommended set-up

Spring Preload...................... 9 mm
Compression adjuster.......... 12 Clicks

Spring

Part No ................................ 60281-11
Free spring length................ 165 mm
Spring rate........................... 100 N/mm
Preload adjustment range.... 0mm-14mm

Shock absorber data

Length ......................................... 264 mm
Stroke ......................................... 52 mm

Spring Preload

Adjuster

Öhlins Racing AB

Box 722

SE-194 27 Upplands Väsby, 

Sweden Phone +46 8 590 025 00

fax +46 8 590 025 80

© Öhlins Racing AB. All rights 

reserved. Any reprinting or 

unauthorized use without the 

written permission of Öhlins 

Racing AB 

Compression 

adjuster

Summary of Contents for YA 559









Reviews: