OHAUS ISLD04HDG, Instruction Manual

Page: 11 / 126

t
roubleShooting
Problem Cause Solution
Unit fails to power on Missing or blown fuse Add or replace fuse as necessary. If problem persists, please contact your Ohaus Representative for repair.
Unit is excessively noisy Rattling or ticking sounds may
indicate a loose screw on the tray Ensure that tray is secured tightly. If problem persists, please contact your Ohaus Representative for repair.
E1
RTD open or over temperature
above 100ºC
This error cannot be fixed by end user. Please contact your Ohaus Representative for repair.
E2
RTD shorted or temperature
below 0ºC
This error cannot be fixed by end user. Please contact your Ohaus Representative for repair.
E3
Drive system failure
Loose suction cup foot
Ceased bearing
Drive belt broken
Remove the mechanical obstruction. In the event a foot (suction cup) has come loose from the bench top, firmly
press down on the four (4) corners of the unit creating a strong suction to the work surface (DO NOT place on
bench mat). If problem persists, please contact your Ohaus Representative for repair.
E4
Unit overload or
Loose suction cup foot
Ensure the load is evenly distributed and does not exceed the maximum load capacity for the unit. In the event
a foot (suction cup) has come loose from the bench top, firmly press down on the four (4) corners of the unit
creating a strong suction to the work surface (DO NOT place on bench mat). If problem persists, please contact
your Ohaus Representative for repair.
E5 Unit temperature is above 80˚C
Press the standby button to turn the unit off and allow it to cool. If the E5 error persists, switch the unit off and
contact your Ohaus representative for repair.
To clear error press the standby button
10
EN