OHAUS GT 210, Directions For Use And Instructions For Installation

Page: 109 / 121

70
MAINTENANCE
Error Codes List Error Codes List Error Codes List Error Codes List Error Codes List
The following list describes the various error codes and which can appear on the
display and the suggested remedy.
Data Errors Data Errors Data Errors Data Errors Data Errors
0.0 Transient error (hardware error, probably static discharge). If error persists,
the balance must be serviced.
Tare Errors Tare Errors Tare Errors Tare Errors Tare Errors
2.0 Balance is unable to stabilize within time limit after taring. Environment is too
hostile or balance needs recalibration.
2.1 Power on load out of specification.
Calibration Errors Calibration Errors
Calibration Errors Calibration Errors
Calibration Errors
3.0 Incorrect or no calibration weight used for calibration. Recalibrate with correct
weights.
RS232 Errors RS232 Errors RS232 Errors RS232 Errors RS232 Errors
4.0 Bad RS232 frame. Check RS232 menu parameters and correct.
4.4 RS232 buffer is full (if installed). May occur if no printer or computer is
connected to the interface. To clear buffer, turn balance off or enter Print menu
and select END.
4.5 Function is disabled by the Lock switch.
User Errors User Errors
User Errors User Errors User Errors
7.0 User entry out of bounds.
7.1 Bad percent (%) mode, sample too low.
7.2 Number outside of display capacity.
Over-Under Load Errors Over-Under Load Errors Over-Under Load Errors Over-Under Load Errors Over-Under Load Errors
8.0 Hardware error causing an internal weight signal which is too low. Check if
platform or platform support is off. If not, the balance must be serviced.
8.1 Hardware error caused by an internal weight signal which is too high. Check
load on the platform which may be excessive. If error persists, the balance
must be serviced.