Defender 3000 Indicators Service Manual
EN-39
5.4
Function Label
Replacement
1.
Isolate the top housing follow Section 5.1.1 for i-DT33P and section 5.1.2 for i-DT33XW, and
disconnect the function label cable from the main PCB.
2.
Carefully remove the old function label from the top housing. It is held in place with a strong
adhesive.
3.
Clean the top cover and remove all traces of adhesive.
4.
Remove the protective backing from the back of the new function label. Carefully position it on the
top housing, starting at the bottom of the cover. Use a rolling motion to smooth it into position.
Note:
For i-D33P, before pasting the function label, place the PC panel and the keyboard in the
position as picture shown below.
5.
Reconnect the function label cable and reserve step 1 to complete the indicator assembly.
6.
Power on for the function test.
