CKW-55 CHECKWEIGHER
EN-17
Press the
TARGET
button to initiate check weigh entry sequence. UNDER flashes momentarily
to indicate the first parameter to be entered. The last Yellow and the first Green Bar Graph
segments are lit during entry.
The display flashes the last Minimum range value entered. Use the numeric keypad to enter
a new Minimum range value.
Note
: -NO- is displayed if the entered value is out of range or is not compatible with the
graduation settings, (refer to Section 3.6.1).
Press
TARGET
to accept the entry. The display will freeze momentarily to confirm the entry.
OVER flashes momentarily to indicate the parameter to be entered next. The last Green and
the first Red Bar graph segments are lit during entry.
The display flashes the last maximum range value entered. Use the numeric keypad to enter
a new Maximum range value or press
C
to clear. .
Press
TARGET
to accept the entry. The display will freeze momentarily to confirm the entry.
END appears momentarily to confirm end of checkweigh entry sequence. The Indicator
returns to active checkweighing mode.
NOTES
: 1.Values entered can be from 1d to Full Scale capacity.
2.Minimum range value cannot be greater than maximum range value unless both
values are negative.
3.For entry in the lb:oz units, the first decimal point entered is used as the lb oz
separator, (eg. an entry of 2.08.3 = 2 lb 8.3 oz. At least one digit must be
entered for the lb location, eg., an entry of 0.15.9 = 0 lb 15.9 oz.
Programming Accept Range by Numeric Key Entry
In the Mode menu, set Checkweigh to On and Set Point Input to Range (refer to Section 3.6.3).
NOTE
: The under and over set points are included in the Accept range.
