EN-6
Adventurer SL
2.2.2 Assembly of Models AS64, AS214, AS313 (Cont.)
4. Install the glass doors in the sides of the Draft Shield framework.
Note
: The glass doors must be inserted in the Draft Shield framework before
you insert the top door; likewise you must remove the top door before
you remove the side doors.
• Hold and position each door so that the handle is near the front of the
balance and the small notch on the bottom edge of the door is lined up
with the tab that protrudes from the side of the balance housing
(shown below).
• Insert the top edge of the glass door into the recessed area under the top
cross-member of the Draft Shield framework.
• Slide the notch on the bottom edge over the tab and slip the door in
place.
5. The door may now be opened by sliding it toward the back of the balance.
Tab on side of
balance housing
Cross-member
on top of Draft
Shield
Close-up of notch
Close-up of tab
Side Door Panel with
handle near front
Notch on bottom
edge of door
Models AS64, AS214, AS313
