INSTRUCTION MANUAL
8
4-
Power connection: connect the plug of the machine to a socket. (The engine of the
machine has an IP-65 protection, which means the machine can get wet (but not submerge)
without any risk.
5-
Set up: The machine is now ready for operation. Turn ON the machine by the
ON/OFF
switch
and the machine will begin to blow. Then open the
Inlet Water tap.
The machine will
start throwing some water, and as soon as begins to absorb the foam fl uid, will create a nice
foam jet. You can adjust the intensity and distance of the foam jet by opening more or less
the
Inlet Water tap
. If the foam cannon does not produce a foam jet of about 10 mts, please
refer to the FAQ section, here after.
6-
Stop and Disassembly: Close the
Inlet Water tap
and Turn OFF the
ON/OFF switch
.
It is recommended to clean the inner circuit of the machine after use. To do this, you must
connect the
Inlet Water tap
, this time onto the foam fl uid connection (FOAM) and let the
water run for a few seconds to remove any remaining foam fl uid. Water will come out on the
back of the machine (motor) although this will not damage the machine at all.
WATER TANK AND PUMP
Although Sirocco foam cannon is ready to work without need of a pump and water tank with
the foam mixture, you may fi nd that where you plan to use the foam cannon, you do not have
either enough water pressure (< 2 BAR) or if there is pressure, the water fl ow is weak. In these
cases it is recommended to work with a water pump.
We recommend our submersible water pump with following specifi cations:
POWER: 1.5 HP AND 220 V
HEAD GAUGE RANGE: 15 - 60 M
FLOW RANGE: 1000 A 7000 L/H
WEIGHT: 16,5 KG
You then can choose if to pump only
the water to the foam cannon, or pump
a PREMIX (the mixure of water + foam
fl uid)
Water tank and pump
