Ogura Industrial Corp, Somerset, NJ, USA www.ogura-clutch.com
Install so that there is no misalignment.
When connecting by coupling etc., install so that there is no misalignment (axial
displacement, deviation, declination).
Do not give an impact to the input shaft and output shaft.
If an impact is applied to the input shaft / output shaft, the auto gap device will not
operate normally. Therefore, when inserting a coupling etc. into the shaft, use the
center tap at the end of the input shaft / output shaft.
Set the inner diameter tolerance of the coupling etc. to H7.
The input shaft and output shaft are processed to h7. Set JIS H7 and h7 for the drive side
and the driven side.
Connect the wiring to the clutch and brake as shown in the figure.
Connect the accessory back surge absorption protection element (varistor) to each of
the clutch and brake in parallel. At that time, the lead wires and protective elements of
the clutch and brake have no polarity.
