ARRANGE PARTS INTO GROUPS AS LISTED
IN YOUR PACK CONTENTS UNFOLD COVER
AND PUT ON ONE SIDE
Please check contents before attemping
to construct growhouse.
Veuillez vérifier le contenu avant de
commencer à construire des growhouse.
ORGANISER DES PARTIES EN GROUPES COMME
FIGURANT DANS VOTRE LISTE DE COLISAGE
DÉPLOIENT LA COUVERTURE ET LE METTRE SUR UN CÔTÉ
4xD 8xE 8x8 4xZ 6x4 2x1 12x3
Assemble the base with the above parts.
Once base is assembled build upwards using the parts
listed in step 2.
4xD 8xE 8x8 4xZ 6x4 2x1 12x3
Assembler la base avec les éléments ci-dessus.
Une fois que base est assemblé construire vers le haut
en u lisant les pièces répertoriée à l’étape 2.
ÉTAPE
8xE 4xB 6x4 4xz 12x3 8x8
This forms the next level.
Once competed build the next level with parts listed in
step 3.
Celui-ci cons tue le prochain niveau.
Une fois a par cipé à construire au prochain niveau
avec des pièces énumérées dans étape 3.
ÉTAPE
2xB 2xD 8xE 8x8 6x4 8x3 4xZ
This forms the next level.
Once completed build the next level with parts listed in
step 4.
Celui-ci cons tue le prochain niveau.
Une fois la build terminée au prochain niveau avec des
pièces énumérées à l’étape 4.
ÉTAPE
4xA 2xC 1x1 2x4 4x8 6x5 2xE
This forms the next level.
Once completed build the next level with parts listed in
step 5.
4xA 2xC 1x1 2x4 4x8 6x5 2xE
Celui-ci cons tue le prochain niveau.
Construire une fois terminé, le prochain niveau avec des
pièces énumérée à l’étape 5.
ÉTAPE
2xJ 1xH 1xY 2x8
This forms the next level.
Once completed, place the cover (Y) over the frame and
a ach.
2xJ 1xH 1xY 2x8
Celui-ci cons tue le prochain niveau.
Une fois terminé, placez le couvercle (Y) sur le cadre et
fixez.
ÉTAPE
Once assembly is complete you will need to ghten the
frame by pushing down on two rods at a me, forcing
them closer together. (Repeat from all angles, as shown
in the picture below). This will result in a ghter and
smaller frame, enabling the greenhouse cover to slide
easily over the frame.
ÉTAPE
8xE 4xB 6x4 4xz 12x3 8x8
2xB 2xD 8xE 8x8 6x4 8x3 4xZ
en appuyant sur les deux ges à la fois, forçant plus près
ensemble. (Répéter sous tous les angles, comme illustré
dans l’image ci-dessous). Cela se traduira dans un cadre
plus serré et plus pe t, ce qui permet la couverture de la
serre à glisser facilement sur le châssis.