Connect the air hose and then the wire harness to their appropriate connectors. Carefully attach the side
board onto the base. Align and insert the two metal bars on the base into the holes under the metal plate. As
pictured below.
Use two screws to attach the side board and close the zipper. As pictured below.
Connect the air hose and
wire connecters.
Reattach the PCB cover and fold up the backrest until it locks into position.
Open box 3 and remove the two side boards. Locate the two zipper heads at bottom edge of the side board.
Unzip these two zipper heads to both ends. On the side board, there are two metal plates. Locate the hole
under each metal plate. As pictured below.
Unzip these two zipper heads to both ends.
Locate the hole under each metal plate.
11
13
14
12
Summary of Contents for OG812
Page 1: ...INSTALLATION MANUAL OG812 ...
