Controller Diagram
Product Operation Guide
7
6
For a brief demonstration of the
features of the massage cushion,
press the DEMO button. The unit will
briefly go through each function.
The L.E.D. light will blink to indicate
active function. Once completed,
the unit automatically turns off.
While the massage function is
activated, press either button to stop
and focus the massage action in one
place. Once the unit is operating in
Spot massage, you may adjust the
mechanism position by holding down
either button until the desired position
is reached. The Up Arrow will move
the mechanism upwards and Down
Arrow will move it downward. Once
you release the button, the
mechanism will stop in the place.
For soothing heat, when massage
is on, simply press the ON button
and the corresponding red L.E.D.
light will illuminate. To deselect,
press the OFF button and the
correspinding L.E.D. light
will turn off. For your safety, heat
cannot be turned on if massage is
not selected.
To turn on the massage functions, first
press the Power button. The L.E.D.
indicator will illuminate and confirm your
selection. To turn off the massage
functions, simply press the button again.
The L.E.D. indicator will blink while the
massage mechanism returns to its
lowest point and then it will turn off.
The function and operation mode is
similar with Spot massage. Adjust
the mechamism position and the
up-down partial massage will act
around the position you choose.
The massage mechanism focuses
on upper part of the back
The massage mechanism travels
up and down the whole back
The massage mechanism focuses
on lower part of the back
Spot Massage
Heat Button
Partial Massage
Upper Back
Full Back
Lower Back
Demo Button
Power Button
NOTE: There is a 15-minute auto shut off
on the unit for your safety.
i. Preparation before use
A screw is applied on the back of the product to protect the massager
apparatus during shipment. Remove the screw before use.
Use the equipped wrench to remove the screw and insert the power cord
provided into the opening.
●
●
ii. Placing the massager
Operation instruction
The massager is equipped with back strap that allow user to faster onto
most chairs.
Place the massager on a chair, wrap the two ends of the strap round the
back of the chair and secure with Velcro.
●
i. [Power]
Insert the power plug into the electric outlet. If the rollers are not at the
bottom position, the light of the [Power] button will flash and the rollers will
return to the bottom position. Press the [Power] button, the product enters
the standby mode, and the [Power] indicator light is on.
Press [Upper], [Full] or [Lower] button to start massage function. There is
a 15-minute shut off for each usage. When the 15-minute time is over or
if you press the [Power] button during operation, the unit will stop function-
ing, all the lights on the panel will turn off and the massager rollers will
return to the original position.
●
●
●
