4
ofs.com
imagine a place®
800.521.5381
Assembly instructions
Gathr assembly instructions
Tools/hardware required:
Impact screwdriver
#2 Quad drive bit
2-12" Squeeze clamps
Level (minimum 3' recommended)
Hardware: HK-15
Connecting ganging seats
Note
: If using a back panel (with or without colonnades), you must attach the back before
connecting the seats to one another. Refer to
1.
Slide the seats together and level them with one another.
(Figure A)
2. Next make sure that they are flush with one another in the front, back, and all edges. Use
squeeze clamps to hold in place and verify that all edges line up.
3. Access the six pre drilled holes from the cutouts provided in the end panels. Use the HK-15 #8
x1.5 screws and attach the seats together.
(Figure B)
Pre drilled holes
Access cutouts
Figure A
Figure B
HK-15
Back panel not shown in this view for
clarify purposes.
Note:
Back panel will be
installed prior to this step
