30481
3x20mm
Hex Screw
( 4 Pcs )
* Only use this 6.3mm tapered cone
for threaded crank shaft with drive
nut.
10330
7mm
Tapper cone
10098
SG
Clutch Nut
SG Type
Crank Shaft
30481
3mm
Nylon Nut
30481
3mm
Nylon Nut
30480
Engine Mount
* Put the nylon nut
into the groove of
the engine mount.
10010
Clutch Shoes
10102
Clutch Spring
3x5mm
Screw
3x8mm
Washer
34110
5x10x4mm
Ball bearing
40244
5x9x0.3mm
Washer
40244
5x9x0.3mm
Washer
M-27B
Clutch Gear
( 12T/16T)
Clutch Gear for Option
40231
11T/15T
40232
13T/17T
39242
5x8x2.5mm
Ball bearing
( 2 Pcs )
40229
2-Speed
Clutch Bell
ASSEMBLY OF THE 2-SPEED CLUTCH BELL
* Fit the flywheel using
a pair of the plier and
cross wrench.
10091
Pilot Shaft
10329
6.3mm
Tapper Cone
ASSENBLY OF THE ENGINE MOUNT
10040
3 pin
Wheel
Threaded Crank
Shaft
Notes:
Non-Pull Start Engines...
• Alum. Washer behind the flywheel is not needed when using Force engines or similar types. O.S. Engines will require washer spacer.
• To check!..place the brass corn against the engine bearing, then flywheel. You should be covering one or two thread of the engine shaft. If this is the case, you do not need an additional washer behind the flywheel.
You must cut the engine shaft if too long. Count 6 threads in front of the flywheel and mark. This is all you need to tighten the clutch nut and mount the flywheel.
Force Pull Start Engine w/threaded shalf...
• Force Pull Start Engines required NO spacer and no shaft cutting. The engines comes with an alum cast driver washer, you use this part as the spacer, not the alum. washer shown. Also, use the special flywheel brass corn.
This corn fits the thread shaft diameter so you can tighten the flywheel against the drive hub.
#10040 (stock)
3 Pin
Flywheel, Taper
#10043
3 Pin
Flywheel, Fan
* Place the clutch shoes
with the clutch springs
over the 3 pins of the
flywheel.
Using a screw driver as a lever,
bend the small end of the
clutch spring behind the
clutch nut and press
down to snap shoe in
place.
* Fit the flywheel using a cross
wrench or deep socket.
If engine turns when tightening,
hold piston with large thick tie-wraps
and hard wood in exhaust port.
Do not use metal, it will
damage engine.
Options
Clutch Spring
10100 - Springs, Polished, Med.
10101 - Spring, Gray, Hard
10102 - Spring, Black, Stock
Clutch Shoes, 3 shoe clutch
10010 - Shoes, Carbon Material, Black
10011 - Shoes, Alum. CNC Blue, Lite Weight
10012 - Shoe, Alum. CNC Purple, Med. Weight
Option
10799
Flywheel Wrench
Summary of Contents for Titan Monster Track 4WD
Page 32: ......
Page 33: ...APPENDIX PAGES...
