3. Flip the chassis latch outward.
4. Roll the o-rings from the center of the feed through the roller to fit
into the groove on each side of the roller.
5. Flip up the roller retaining lock clips.
6. Remove the supply roller from the instrument. Slide the supply
roller into the perforated end of a roll of chart paper.
7. Hold the loose end of the chart paper in your left hand and the sup-
ply roll in your right hand so that the blank side of the chart paper is
facing upward between your left hand and the roller. Slip the chart
paper under the right hand side plate. Carefully maneuver the chart
paper so that the perforations fit into the sprocket and drive rollers.
8. Press the supply roll tension arm toward the left side plate. Set the
supply roller pins into the notches of the side plates and snap the
roller retaining lock clips down into the lock position.
9. Pull the chart paper out from the supply roll until it extends out
beyond the top of the door.
10. Press down on the right-hand side plate. Flip the chassis latch up
(press the latch against the side plate until it snaps into place).
Close the door. Reconnect the signal and power cables. Rotate
the thumbwheel on the outside of the door to advance the chart
paper as desired.
OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ofite.com
12
Roller Retaining
Lock Clip
Reroll Roller
Chassis Latch
Right-Hand Side Plate
Supply Roll
Supply Roller
