10
Officine Gullo
TURNING ON
Switch on the main switch installed above the appliance. Turn the control knob corresponding
to the hotplate from position “0” to the degree of heating desired, between 1 and 6. The light
comes on, as son as the power supply is on.
The green light indicates the presence of electrical tension. To turn off the hotplate, turn the
knob back into position “0”. The hotplates are made up of a nucleus and a crown.
Turning the knob, as indicated above, only the nucleus of the hotplate comes on; turning the
knob beyond position “6”, the crown also comes on and the temperature can, once again be
regulated from pos. “1” to pos. “6”.
CARE AND CLEANING INSTRUCTIONS
Attention! During cleaning, do not wash the external parts of the appliance with direct
sprays of water or with high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the
appliance ensures the perfect functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must
be washed with hot water and neutral detergent, then rinsed thoroughly in order to eliminate
all traces of detergent; after which, dried with a dry cloth. Do not use abrasive or corrosive
detergents.
Cleaning the crystal
The crystal must be cleaned with degreasing liquids, acids containing vinegar and lemon,
suitable for cleaning ceramic and crystal. It is advisable to carry out this operation when
the crystal is not completely cold, so that spilled food, burned grease, etc. can be softened
using a damp cloth and removed whilst still warm with an ordinary scraper, in order to avoid
damaging the crystal surface.
Do not use abrasive or corrosive detergents.
Important:
As well as ordinary cleaning and maintenance, it is advisable to have the installation
checked by an installer at least once a year.
It is therefore suggested to draw up an after-sales assistance contract.
CLEANING BURNISHED BRASS SURFACES
No synthetic protective varnishes have been used to obtain the special burnishing effect on
the burnished brass details in order to avoid spoiling the beauty of the brass with an artificial
patina. The antique finish of the surface is the result of natural oxidation that has simply
been accelerated. All the natural antique finish brass surfaces can be cleaned with mild
soap and warm water, accompanied by the use of an abrasive pad (the green color type
used for washing dishes). It is recommended that the metal be rubbed, uniformly applying
light pressure, use caution as this will remove some of the patina if rubbed excessvily.
The brass details should then be dried.
Summary of Contents for PVS4EM
Page 2: ...2 Officine Gullo...
