Officine Gullo PVS4, Instructions For Installation And Use Manual

Page: 10 / 16

10
Officine Gullo
Indications :
• Each hotplate is connected to an energy regulator (selector), giving the possibility to cho-
ose from 6 different temperatures. For the first cooking, it is advisable to use the highest
temperatures.
• each hotplate is provided with a temperature limiter which comes into function when the
temperature reached may damage the crystal.
• When the crystal surface heats up, the residuous heat light comes on, corresponding to the
hotplate in function. This indicator does not go off until the crystal maintains a high tempe-
rature, even with the hotplate turned off so as to avoid danger of burns.
Warnings :
• Do not use pans or any recipient with the bottom in aluminium or with a tin coating.
• Do not use terracotta pots as they could break or crack and therefore become unhygienic.
It is advisable to use stainless steel pans with a smooth, flat bottom and with an adequate
diameter for the heating area. If cast-iron pans are used, be careful not to slide them on the
crystal, in order to avoid any scratches. Make sure that the bottom of the pans has been
dried well before placing them on the top; avoid banging the crystal, especially with sharp
or pointed objects.
• Pay attention never to cover the crystal with sheets of aluminium paper or anything similar,
during use.Never start up the appliance without oil.
Any kind of food (meat, fish, legumes, eggs, rice, vegetables, etc.) can be cooked on the glass
ceramic coking tops, providing suitable pans are used..
TURNING ON
Switch on the main switch installed above the appliance. Turn the control knob corresponding to
the hotplate from position “0” to the degree of heating desired, between 1 and 6. The light comes
on, as son as the power supply is on.
The green light indicates the presence of electrical tension. To turn off the hotplate, turn the knob
back into position “0”. The hotplates are made up of a nucleus and a crown.
Turning the knob, as indicated above, only the nucleus of the hotplate comes on; turning the
knob beyond position “6”, the crown also comes on and the temperature can, once again be
regulated from pos. “1” to pos. “6”.