Officine Gullo IIS4, Instructions Manual

Page: 12 / 24

12
Saucepans must always be kept a small distance apart. They should not touch each other. When you remove the
saucepan, it is advisable to switch off the cooking zone to prevent the heating system from switching back on automatically
should you happen to replace the saucepan.
Metal objects heat up very quickly if placed in the heating zone when it is in operation. It is therefore advisable not to place
objects other than saucepans on the induction hob (cans, closed tins, aluminium trays, cutlery, rings, keys, watches, etc.)
generator.
Do not place credit cards, phone cards, cassette tapes or other magnetic objects on the pyroceram plate with induction
system.
The induction generator has an internal cooling system. Make sure that the air inlet and outlet holes are not blocked by
objects (paper, rags or other). This could cause overheating and lead the induction generator to switch itself off.
Do not allow liquids (water, oil or other) to enter the induction generator.
Do not clean the generator with a jet of water.
If the pyroceram top is cracked or broken, switch off the induction hob and disconnect the electricity supply. Do not touch
any of the internal parts of the induction generator.
Safety during installation, maintenance and controls.
course authorised by the manufacturer as regards the induction generator.
Moreover, they must meet the requirements set by the relative authorities as regards the electrical and electronic safety of
installations. Generally speaking, work should only be carried out on the induction generator component after it has been
disconnected from the electricity supply.
The induction generator must be switched off and disconnected from the power supply and electricity network.
The safety and protection installations must be replaced and reinstalled at the end of the above operations, in keeping
with the international, national and regional regulations and laws on safety, thus ensuring correct and safe usage of the
component.
Reproduction or use of unauthorised spare parts.
Reproductions or changes to the induction generator component are not permitted. Contact the manufacturer if you observe
any changes to the induction generator. To ensure safety, always use original spare parts, authorised by the manufacturer.
The manufacturer declines all responsibility in the event in which non-original spare parts have been used.
Improper usage.
The good working order of the induction generator components is only guaranteed in the event of correct usage as
described in this manual and as regulated by the international, national and regional laws and regulations on safety and
electromagnetic compatibility, which regulate components such as the induction generator.