Officine Gullo
8
TECHNICAL ELECTRICAL DATA TABLE
MODELS
Dimensions
cm
Power supply
Power
max kW
Absorb.max A
Power supply
cable
FE8
80x57,5x57h
230Vac 50/60 Hz
3,05
13,3
3 x 2.5 mm²
FE10
100x57,5x57h
230Vac 50/60 Hz
3,05
13,3
3 x 2.5 mm²
ELECTRIC CONNECTION
The appliance is supplied without the connection cable.
In the event that it has to be substituted, proceed as follows:
•
Disconnect the power supply.
•
Remove the back panel.
•
Disconnect the cable from the junction-box situated at the back.
•
Loosen the cable blocker and pull out the cable.
•
Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in
the junction box and fix them into place.
•
Block the cable with the cable blocker, and reassemble the back panel. The earth wire must be longer than the others
so that if the cable blocker should break, it will disconnect after the tension wires.
N.B.
The connection cable must have the following characteristics: it must be at least type H05 RN-F (resistant to a
temperature of at least 150°), and must have an adequate section for the power of the appliance (see technical data
table).
EQUIPOTENTIAL
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the symbol
.
Attention:
The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
9
Officine Gullo
USER MANUAL
INSTRUCTIONS FOR USE
Attention!
•
Use the appliance only under surveillance
TURNING ON AND ADJUSTING THE MULTIFUNCTION OVEN
Oven:
The hot air made to circulate by the fan is distributed in all parts of the oven chamber to
ensure even cooking results. Since the oven chamber is heated evenly, different foods
can be cooked together on different rungs. Turn the knob round to the hot air and set
the temperature wanted.
The oven does not have to be preheated because the hot air heats it up very quickly.
To turn the oven on, turn the selector knob (see figure) to the right or left into one of the
following positions
Top + bottom heating element W 2600
Bottom heating element W 1600
Top heating element W 1000
Grill heating element W 2000
Grill heating e fan W 2036
Top + bottom heating e fan W 2636
Fan Oven W 3036
Fast defrost W 36
The green pilot light turns on to indicate the oven is powered.
After having selected the cooking type, turn the timer knob (see figure) to the left on
the manual position or to the right, positioning it on the time chosen, ranging between
0 and 120 minutes. In this last position, once the time set has elapsed, the acoustic
signal sounds and the oven turns itself off at the same time.
After having set the cooking time, turn the thermostat knob (see figure) to the right,
positioning it on the temperature wanted.
Caution:
when the oven is on, the door must be kept shut otherwise the knobs and
protection sheet could get hot and be damaged.
Grill:
When using the grill the oven door must be closed and position the thermostat knob
on position
200°C
