manualshive.com logo in svg

OfficeSource PB21236, Assembly Instructions, Page: 4 / 4

Share
Download
OfficeSource PB21236 Assembly Instructions Download Page 4

®

®

www.officesourcefurniture.com

PB21236

ASSEMBLY INSTRUCTIONS

®

®

www.officesourcefurniture.com

PB21230ACR

ASSEMBLY INSTRUCTIONS

STEP 5. STACKING ON PANELS

Note: When using 2 stacked 12” panels, 24” high posts must be used.

5.1

Attach first level of panels as described in Step 3. Insert 2nd level of panels between 24” high posts in 

same fashion.

5.2

Tighten locking nut on the threaded rod and place caps on top of divider post.

USER
SIDE

5.1

5.2

5.1

STACKED
INCORRECTLY

STACKED
PROPERLY

3/4” Screw

TOP CAP

Please ensure panels are stacked properly - rails should fit in channels .

Summary of Contents for PB21236

Page 1: ...propriate kit purchased If you do not please contact the dealer that sold you this product a b c b b Regular OR Corner Panel x 1 PANEL PARTS KIT TRANSACTION TOP PARTS KIT Not recommended for use on 24 posts DIVIDER POST PARTS KIT Top Cap x 1 Mounting Plate x 1 1 1 4 Screw x 4 Template x 1 Washer x 1 Locknut x 1 1 Screw x 4 a Divider post x 1 b Cover strip x 3 c Threaded Rod x 1 Regular Panel x 1 3...

Page 2: ...truction 1 5 then install the remaining 3 1 screws in each mounting plate as shown followed by the 4 1 1 4 in the four outside corners of the plate 1 6 1 7 1 6 Install all the remaining mounting plates that will be on your work surfaces following the above instructions Remember when aligning the mounting plates use only the one short screw and do not tighten Filler Panel Regular Panel STEP 1 ATTAC...

Page 3: ...r strips on the post are propery placed Note If using transaction tops proceed to Step 4 3 5 Tighten locking nut Place caps on top of divider post 3 4 Screw 3 1 3 2 Note All transaction tops come with necessary connecting hardware 4 1 Remove nut and washer Slide connecting bracket onto threaded rod and divider post 4 2 Fasten connecting bracket to divider post by tightening locking nut 4 3 Align c...

Page 4: ...nels 24 high posts must be used 5 1 Attach first level of panels as described in Step 3 Insert 2nd level of panels between 24 high posts in same fashion 5 2 Tighten locking nut on the threaded rod and place caps on top of divider post USER SIDE 5 1 5 2 5 1 STACKED INCORRECTLY STACKED PROPERLY 3 4 Screw TOP CAP Please ensure panels are stacked properly rails should fit in channels ...

Reviews:

No comments