®
®
www.officesourcefurniture.com
PB21236
ASSEMBLY INSTRUCTIONS
®
®
www.officesourcefurniture.com
PB21230ACR
ASSEMBLY INSTRUCTIONS
1.4
Install the mounting plate that is to
be fixed at the other end of the work
surface by following steps 1.1 to 1.3
above.
1.5
Temporarily position a panel between
the two mounting plates. Adjust
mounting plates so that a gap of
approximately 1/16” or 2mm is
between the panel and the plate.
1/16” or 2.0 mm gap
1.4
1.5
1.7
After all the mounting plates have been properly aligned, including having the panels temporarily
positioned as per instruction 1.5, then install the remaining 3 - 1” screws in each mounting plate as
shown, followed by the 4 - 1 1/4” in the four outside corners of the plate.
1.6
1.7
1.6
Install all the remaining mounting
plates that will be on your work surfaces
following the above instructions. Remember
when aligning the mounting plates use only
the one short screw and do not tighten.
Filler Panel
Regular Panel
STEP 1. ATTACH MOUNTING PLATE
1.1
Fold sides of template downward and
position template tight against work
surface corner.
1.2
Expose double sided tape and
position mounting plate inside the
template opening.
1.3
Remove the template and install the
short 1” screw into one of the
inside holes. Do not tighten.
DO NOT INSTALL ANY OTHER SCREWS
1.1
1.2
1.3
®
www.officesourcefurniture.com