IMPORTANT NOTE:
1. Use hand tools only for assembly as power tools may
cause damage
2. Carefully remove any staples used for packaging.
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Attach two Cross Supports (E) to one Left Side Frame (C) and one Right Side Frame (D) using six Bolts (H3) for each side frame.
DO NOT
FULLY TIGTHEN BOLTS (H3). Note: Repeat step for remaning Cross Supports (E) and Side Frames (C & D).
STEP 2
Attach Corner Frame (G) to assembly using four Bolts (H3).
DO NOT FULLY TIGTHEN BOLTS (J2).
PART QTY
H1.
Bolt (1-9/16’’) . . . . . . . . 4 + 1 Extra
H2.
Bolt (23/32’’) . . . . . . . 10 + 1 Extra
H3.
Bolt (13/32’’) . . . . . . . 17 + 1 Extra
H4.
Bolt (25/32’’) . . . . . . . . 2 + 1 Extra
I.
Flat Washer . . . . . . . . . . . . . . . . . 11
J.
Allen Wrench . . . . . . . . . . . . . . . . . 1
NWP25L-BK
NEWPORT L-SHAPED COMPUTER DESK
ASSEMBLY INSTRUCTIONS
NWP25L-BK
NEWPORT L-SHAPED COMPUTER DESK
ASSEMBLY INSTRUCTIONS
STEP 3
Attach one Back Support (F) to each side frame assembly using one Bolt (H4) and two Bolts (H1) for each Back Support (F).
APPLY FIRM
PRESSURE TO ALIGN ASSEMBLY AND FULLY TIGHTEN ALL BOLTS USING ALLEN WRENCH (J).
STEP 4
Attach both Glass Tops (A) to assembly using four Flat Washers (I) and four Bolts (H2) for each Glass Top (A). Attach Corner Glass Top (B) to
assembly using three Flat Washers (I), two Bolts (H2) and one Bolt (H3).
FULLY TIGHTEN ALL BOLTS USING ALLEN WRENCH (L).
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING COMPUTER DESK.
© Office Star Products August 2013
STEP 1
STEP 2
STEP 3
STEP 4
PART QTY
A.
Glass Top . . . . . . . . . . . . . . . . . . . 2
B.
Corner Glass Top . . . . . . . . . . . . . 1
C.
Left Side Frame . . . . . . . . . . . . . . 2
D.
Right Side Frame . . . . . . . . . . . . . 2
E.
Cross Support . . . . . . . . . . . . . . . . 4
F.
Back Support . . . . . . . . . . . . . . . . . 2
G.
Corner Frame . . . . . . . . . . . . . . . . 1
