Offgridtec PSI-PRO Inverter
4 Installation
Konto Sparkasse Rottal-Inn
Konto: 10188985
BLZ: 74351430
IBAN: DE69743514300010188985
BIC: BYLADEM1EGF (Eggenfelden)
Sitz und Amtsgericht
HRB: 9179 Registergericht Landshut
Steuernummer: 141/134/30045
Ust-IdNr: DE287111500
Gerichtsstand: Mühldorf am Inn
4.3
Assembly
To ensure natural thermal convection, you should install the inverter in a place with sufficient aircirculation
and a minimum distance of 150mm from the upper and lower edges of the inverter.
Additional ventilation is higly recommended when installed in a housing
PSI-PRO 12/2000
Schritt 3:
Wiring
The alternating current loads must be determined by the continuous
output power of the inverter. The overvoltage power of the AC load
must be lower than the current surge power of the inverter, or the
inverter is damaged.
•
Set the inverter switch to the off status before wiring.
•
Do not close the circuit breaker or fuse during wiring. Make sure that the lines of "+" and
"-" poles
are correctly polarized.
•
A fuse must be installed at the end of the battery, the current of which is 2 to 2.5 times
the rated
current of the inverter. The distance between them is not more than 150mm.
•
The positions of the terminals and connections on the side vary from the inverter models.
General information
Offgridtec GmbH
Im Gewerbepark 11
84307 Eggenfelden
WEEE-Reg.-Nr. DE37551136
Contact
Tel: +49 8721 91994-00
Email: [email protected]
Web: www.offgridtec.com
GFR: Christian & Martin Krannich
